- New page on my web site Polyurethane bushings install
- f 41 brackets
- Inner Tie Rod, zerk clearance issue, 65 Chevelle
- hotchkis springs
- Working on a Rod End Alternative
- Anyone Want to Split the Cost of Rear Air Lift Bags
- Collapsing steering column member
- 64 chassis specs
- Wheel fitment with disc brakes question
- No brakes!
- opinions
- GM A body drum brake interchange
- Rivets in upper control arms to hold ball joints in
- Just ordered a Lee 670 12.7:1 Power Steering Box
- Stainless Braided Brake Lines
- need answer please!!
- Yet another (simple) drop spindle question
- Rear trans ams calipers on 12 bolt
- Need help finding a good Brake Shop?
- Looking for help to finish.
- What springs to buy?
- front spring interchange 64-67 vs 68-72
- Disk brake question
- Rear Crossmember Braces?
- Power brake conversion
- 70 Chevelle with modern suspension upgrade
- Front sway bar bushings 67
- Rear Lower Control Arms, good idea?
- Correct Lower front Control Arms
- Need a different e-brake setup. Help!
- Line lock
- Installing coil springs
- Centerlink parts
- Moog parts /center link not right/ why?
- Eibach springs with 18's (pics)
- what's the next step?
- Hydroboost questions
- Considering Aftermarket Rear Control Arms
- Rear Lower Control Arms, best choice?
- Which is LH & RH upper Control Arm
- Will this brake setup fit my '70?
- Rear upper control arm frame mount holes elongated
- Loads seen on rear upper control arms?
- Height
- Manual steering box
- Looking for original shims
- Tips for Install of Front Coil Spring Needed
- Spacer/Insulator for Front Coil Springs?
- Brake conversion help needed
- Center Link Differences
- How do I rebuild this?
- Power steering pump
- 12 bolt rear for a 65
- Replacing stock shocks
- jeep steering box cost differences
- Powder Coating
- 1966 chevelle
- Been a while since brake work, can I check the MC bore easily?
- BMR complete handling kit.
- Hydroboost & Wilwood Master Cyl Not Bleeding
- 1969 SS With Power Brakes
- What Master Cylinder for Hydroboost?
- "Custom" Alignment?
- New CPP rear disc installation problem
- Residual pressure valves for rear cylinders
- 71 Parking brake cable adjustment
- What is the Chevelle F-41 spring rated at?
- Rear Drum Diameter
- is there a aluminum manual steering box available?
- Cherokee or Grand Cherokee steering box
- two piece rotors
- Lowering Question
- Safety and Quality - Suspension ??
- Manual disc m/c bore size
- Tubular Control Arms
- Back to basics: Brake rod clevis in top or bottom hole for manual?
- Hotchkis frame braces hitting the floor?
- manual to power steering
- lakewood lower control arms
- 67 steering column floor mount?
- Body bushings (Input please)
- Front shock tightening question
- rockauto 5% code
- help; no brakes
- manual to power steering on 67 chevelle
- front sway bar bracket bent?
- Suspension- shocks w/ overload.
- Lakewood lift bars and no hop bars
- drum to disc on 70 el camino
- Question about proportioning valve
- Original brake lines - Keep or toss?
- What exactly do these brake system valve do? See pics. Thx!
- z BAR BRACKET
- Apparently semi-common Hydroboost conversion issue, the return line
- For those that have done the disc swap
- 94 TA: spongy no pedal, with no air in lines.. possibly bad abs unit?
- G body to A body
- Brake Booster Install ?
- Coil Over Spring Rate
- rack and pinion
- Vibration
- Performance Suspension kits
- Power Steering Return Hose
- Brake booster ?
- Alternator belt rubs power steering pump
- New IMCA Chevelle Frame
- hopefully easy hydroboost question.
- torque specs?
- Dorman rag joint 31011 - exact fit or '"not exactly"
- Brake Bleeding question?
- Where do I start? Bodymounts
- Yet another LS1 brake question
- Bang for the buck, whats the best way to make my '69 SS handle better?
- 1" Drop Springs
- Need help with proportining valves, etc.
- Steeroids, yes or no?
- SSBC 68 Chevelle brake conversion
- School me on brake plumbing PLEASE!
- Picture of boxed control arms?
- This time a brake problem!
- parts match?
- Monroe Sensa Trac ?????
- New Product!= 1.250" Front Sway bar and Sway Bar Kit- $250 a kit!
- Heidt's Chevelle rear 4 links
- Question for Suspension Experts
- Changing pitman seal 98 GC Box
- 67 adjustable centerlink?
- Cheap A-arms on ebay
- GC steering box - pressure port conv. fitting 1447
- front upper control arm shaft bushing removal help
- 1966 Power steering hose help
- check this out
- Brake Bleeding Question
- Someone mentioned late model Camaro or Corvette swap??
- Is my Master Cylinder bad?
- How much to get your frame checked.
- Any Opinions On Rear Trailing Arms?
- Need info on brake conversion
- coil spring removal, what am I doing wrong!
- Going manual steering questions?
- airbag conversion parts?
- Offset
- Anyone purchase from justpowerbrakes.com?
- Installing Front Upper Control Arm Bushings
- Power steering pitman arm for 67 chevelle
- adjustable top links
- car leans to the left
- Tie rod adjustment sleeve hitting swaybar?
- brake swap almost done
- Third gen camaro steering box on Chevelle
- Brake drums
- Gettin It To Hook??
- Front springs 67 chevelle
- Sway bar
- Short upper arm on a 3 link?
- grand box in elco
- Another helping hook-up ?
- Jiml82 could you explain the protractor sweep method
- whoa!!! and the next step is???
- How to plumb lines to disc/disc system?
- What do these shimms say?
- DO I have the right MC??
- Spring Removal - Step By Step - With Pictures
- converting to power brakes on 67 SS
- Any suggestions on a p/s hose kit for my '69..
- Hydroboost & Fast Ratio Steering Box Together !??
- frame bushings
- 4 wheel Discs
- What type and brand of brake pads ?
- Need help finding a part
- Anyone have edelbrock adjustable upper control arm
- Can't find 64 rear end housing "upper control arm mount" bushings
- Are the Repo Delco Spiral Shocks any Good?
- Having front end aligned for drag racing?
- Control Arm Orientation
- Rear bump stops on a 9" rear end
- New MC question
- how to remove upper control arm bushings (video)
- Stock front suspension 68 malibu
- 2 In. Drop
- Poly body mounts ?????
- LS1 Rear Discs change wheel backspacing/center???
- What Master Cylinder
- Poly Sway Bar Link Kit
- new rear trailing arms
- rear springs
- Whats everyone doing for rear control arm bolts?
- basic steering box anatomy question
- a arm interchange
- Cut front springs today
- Anyone convert stock PS hose to metric end fitting?
- Drop spindles, drop springs or both.......
- going from power steering to non power
- Improving LakeWood No-Hops
- 1967 El master probs
- shocks for 2" lower
- Alignment/camber bolt problem
- Ball Joint Removal Tool Question...With Picture.
- Calipers standard or different sizes?
- Rear poly bushings
- Pitman arm alignment question
- how do I get these Drums off?
- Converting drum spindles 70 chevelle
- Replacing Coils - No motor in Car
- DM Products control arms
- Control Arm shaft studs
- Offset Control Arm shafts -- Brand?
- How Do I Remove Ball Joint Rivets ?
- steering gear box psi????
- Please Help Me With Ball Joint - Video
- cannister or pump for additional vacuum for brakes
- Clearance Question
- brake rebuild question
- Bleeding PS Gear & Pump ?'s
- 64-65 Tilt steering column
- Suspension Upgrade
- Upper control arm....alignment went shim happy
- Lower control arm bushing removal
- '70 El Camino suspension help needed
- Bolt size?
- torque for backing plate
- Front drum brakes question.
- 2" spindle drop and spring drop, too much??
- Leaning Wagon / Correct Airlift Airbags?
- Front sway bar install -- flat surface or raised?
- Firewall brake seal
- Frustrating connection leak
- Frustrating connection leak
- Is my PS Spool Valve messed up?
- Factory level ride ?
- hard brakes
- Is this a 66 small block PS pump mount?
- Wahoo--Brake Kit is Here!!!!
- A-arms
- Frontend Rebuild (Pics)
- Gm Disk Brake Question
- rebuilding wheel cylinders
- How many lines to front brakes?
- '67 Power steering pump brackets and pulleys
- Disc Brake Size
- Rear Control Arm Bushings
- ? about brake switch on combination valve
- Opinions on high-speed stability
- Pitman arm choice
- 69 SS Power Brake Problem
- New Springs for 69 SS
- 68 chevelle tie rod question
- Sway Bar
- Rear control Arm Bushings
- FRAME SWAP How To ?