View Full Version : Body Shop
- Is this code 51, autumn gold
- final sanding before paint ?
- added the D96 side stripe....
- "Flush mount" window
- Need an opinion on these wheels
- door lock clips
- body bushings for $475 ?
- shopping for new air compressor - help!
- help cowl induction hood
- 65 cowl hood
- Finally got the rest of my sheetmetal! Advice please.
- Carnuba wax
- Ready to weld?
- Clay Bar Uses
- Back up light lenses
- floor pans
- PPG glass still no good.
- Tubbing questions
- aftermarket 70-72 doors
- epoxy then filler
- 70 chevelle,drilling holes in new fenderwells
- newbie - Should i fill in the emblem holes?
- Question about stripes and cutting in
- Trim below the headlights on 70 Malibu
- gas tank bolts 69 Chevelle at back
- 66 complete trunk pan
- wheel dollys
- Drip Rail Moldings...How to remove & install?
- Block sanding.
- What to do after sandbasting surface rust
- Windshield Trim And Clips 67
- 69 Chevelle window pieces
- ran into snag while welding floors
- 66 driver quarter patch body question
- gas tank paint
- door glass
- SPI Epoxy Shelf Life?
- 70 Chevelle front bumper installation
- Wet sanding questions
- Fonrt clip assembly sequence
- Patch panel cost
- name this body part
- 69 SS eyebrow mounting ?
- 70 Chevelle headlight knob / How to remove?
- Stripping Paint off heads
- Starting bodywork. pics/questions
- The Easy Way To Remove Undercoating!
- Replacing Trunk Pan in a 66': How difficult?
- Welding in floor pans question....
- Bring back faded/oxidized paint
- paint cost
- 66 front fenders
- my new toy
- cowl induction help
- Sandblasting frame
- Perfect paint job?
- Seam Sealer 3M 08656 or Evercoat Maxim - Application help
- Lower fender bolts just spin!! AHHHH
- Jacked up fender...
- Trunk completely rusted out..
- stripe installation question 69 SS
- 69 Chevelle Package Tray
- Removal of minor scrathes in Windows.
- 68 ss hood onto 69 malibu
- Stripe Color Opinion Wanted
- Sheetmetal patching
- Rear wheel lip, where can I get it?
- ss stripes
- replacing and most important aligning all windows
- Hood Spring
- Adjusting Doors On 67 Chevelle
- color poll
- 'A' Pillar repair
- 2 tone paint on my 69 4 door sedan
- 68-69 quarter windows??
- Sealer over burn through to filler
- Blasting vs. Chemical stripping
- 1970 Frame Quandry
- old sheet metal where to start????
- Rear window channel rust
- new toy
- primer thickness
- Finally some color
- Body Alinement
- The $5,000 Paint Job
- Which Seam Sealer???
- 69 chevelle rear window rubber.
- Single stage paint question.
- Hood problems, please help!
- Compressor, Water Separators, Rubber Line
- Body mount/bushing question
- My paint gun is surging while spraying epoxy
- SPI epoxy?
- How would you repair this?
- MANY THANKS to TC Members (Long but Please Read)
- Tips and Lessons-Learned from First Paint Job
- Vinyl Top Dressing
- Will This Work???
- Temporary rust inhibitor?
- 66 Malibu Grille Quality
- 1969 inner fender walls
- Best Wax to remove swirl marks and water spots
- Bare metal stripes??
- Rear bumper removel??
- Welder Help@!@@!
- Looking for a body shop near Columbus Indiana
- Most efficient method for overall paint
- Ebay Chevelle Color Code
- New paint and top
- the body is off
- Paint Color
- painting on a rotisserie
- Sheilding gas
- another Vinyl top
- Windshield Leak
- Chevelle sign..
- 70 chevelle package tray search
- 396 front emblem fit 307 holes?
- 1966 chevelle billet grille???
- paint code 13
- First quarter, some welding done
- Dupont Paints Hot Hues
- Looking for a Eastwood painted gas tank picture
- Correcting Racked Door
- Primer for Dupont B / C ??
- Ripple free panels.
- Use of rust converter?
- How Much Paint Do I Need?
- 1968 chevelle black paint
- 65 Chevelle 2 dr who's floorpans to buy
- Reshape it or fill it?
- rad. support
- possible solvent pop
- New technology for sanding & buffing
- done painting
- 67 Rear Window Moulding Clips Location
- hood trim 1/2" off 66 Chevelle
- Need some advise about winsdshield header..........
- we have color
- Whats this part called???
- U-Pol weld-thru primer
- 68 Chevelle Malibu windshield
- All Body parts can be found here
- Oxidation Removal Before and Afer Pics
- good sheet metal
- POR Chevy Orange / Brush Application
- frame measurements??
- Help Patching some holes
- 2 bottom clips for windshield
- Getting Closer (Pictures)
- Body contour or bulge off.
- time between primer and primer surfacer?
- Help ! Location of Elcamino marker light
- Need PPG/Omni tech sheets
- My first attempt at metal work
- Couple of Questions about painting sheet metal
- Paint code for '72 Black SS Stripes?
- What to do first?...
- underhood gloss?
- 65 Chevelle Frame
- Need advice on fillers
- Need advice on fillers
- Areas of rust on 72 chevelle's.
- 65 Floorpan Replacement advice please
- 1966 chevelle
- 1970 SS under hood color?
- 68 Tunnel Hump Install
- gotta cut out the wheel tubs need some advise
- 1966 chevelle
- Paint booth fumes
- Waxing Primer
- Wheel wells, but not quarter?
- Latest project:low mile original 70 chevelle
- seam sealer quality?
- 68-72 engine compartment
- need help finding grill molding
- Bad to leave on jack stands?
- Assy manuals are for GM workers who already know where to put it
- pinstripping
- July 4th project.
- powder coating bumpers
- If I Change The Body Bushings On My 66 How Much Raise Should I Expect?
- Back glass leak
- less expensive products
- 68 Front Body Mount...
- hood scoop
- replacing the lower quarter on my 70
- Help and advise need
- 67 SS rear panel Black?
- Installing Grille Emblem
- I got 3 weeks free play time, now....
- gas tank resto
- I need a Paint and body shop
- Weld Wire Size for Sheet Metal?
- Applying POR 15
- a couple of more pics of the car with the NEW stripe...
- first time at the track
- quarter glass and window adjustment help - 68
- Sheet metal? Who is good?
- Milwaukee 7"/9" variable speed buffer
- 1968 Fenders
- Eliminate Wing Windows
- uneven 66
- Fender Work
- Questions on using single stage urethane
- know of any high quality body shops in san antonio?
- Anybody have rear axle centerline dimensions?
- Location of paint number
- Seam sealer on new door skin?
- Rust spots in metal revisited.
- Figuring estimate for????
- vinyl roof - roller marks, are these normal?
- Rough estimate on full 1/4 replacement
- insulation between support and rear filler panel
- Is there a 64 El camino bed patch panel for...?
- 67 Chevelle resto underway
- wax or polish
- 65 ss crooked rear emblems
- chalky 67 vent window seals
- uneven 66 (getting close)
- feather fill primer
- 70 Chevelle Wiper Arms...How to remove?
- Anyone try one piece wheelhouses yet?
- How do you seperate wiper arm from wiper blade?
- What order should I do this?
- 70 front end on 71 chevelle
- Wet sanding?
- 1970 Chevelle Sport Sedan 4 Door
- Flex
- What exactly is a "quarter skin"?
- Where to purchase trunk springs for 68-72 chevelle
- Weatherstrip Channel
- 69 quarter window chrome replace
- Off topic but I think we can all relate.....
- Help with '66 winsdhield pillar removal
- trunk torsion bars
- woohoo!! OPGI has FULL quarters for 64 and 65s!!
- Restoration Shop Paint (TCP GLOBAL)
- 67 chevelle half pan help (cut out hump)
- Is supplied air worth the cost
- Mist detailer Products safe on New paint?
- rocker panel replacement
- cleaning powder coat
- front inner fender questions
- Paint vs. thinner
- Plasticoat Bedliner
- Factory primer color?
- Matching body curves
- Car at paint shop
- Front windshield and back glass rubber
|