- drilling holes for 66ss emblems
- etch on bare metal only?
- Buddy needs help looking for super rare metal - '65 A-body
- Body shop taking too long
- trunk support ???
- fibereglass fenders ?
- sand blasted window
- Will a 72 4 door frame fit a 71 2 door?
- 65 door skins
- OPG Plastic Inner Fenders
- z
- BODY MOUNTS
- Correct color for 68
- Need new 70 front fender - who makes the best one ?
- 67 Bezels
- lifting body
- Where to find correct formula for my paint code?
- Patch Panel Question
- gas tank color
- Single Stage Urethane Vs. 2 Stage Urethane
- '68 Grille Extensions Vs. '69 Extensions
- '70 rear window channel
- Should I go with a hood this tall? (Progress Pics)
- jackstands same as tires
- Dent pulling tips
- Flux core welding
- Using a convertible frame
- trunk paint color for 70 SS
- Painter In Metro-Detroit
- anyone tried a Chicago Electric easy Mig 101/1?
- Chemical stripper to remove paint?
- Chrome moulding. base of doors. ??
- 66 body lifting questions
- 66-67 rear bumper braces interchange?
- Steel wool to remove scratches?
- I've Got The '68 Chevelle SS Corner Window Weatherstripping Bluehoos!
- lack of luster on chrome
- if you can help what is a good color for a viny top 70
- bent bumper question
- VALVE COVERS ETCHED
- Anybody ever use Kerosene to clean a car
- 71 chevelle frame compatiblity
- Hood and trunk lid adjustment
- Hood latch....
- Crevis Wax???
- Modified Acrylic ? ? ?
- El camino ? Removing bed rail trim
- Window Felt, Rear Roll up Window Fitment
- Installation of new Hood Springs
- Has anybody painted..
- wheel dollies
- grille emblems
- A question about RUST
- vinyl top trim
- instrument panel
- inside door handles
- 1970 Nova Door Hinge(LH-Lower)--?
- How to get 69 Chevelle paint color?
- Paint Color question!
- Help re rear panel & moldings (69)?
- "spider webbing"
- I got "keyed" over the weekend
- rear window rust
- which wax do you use???
- Trunk weather seal
- MARTINSR, I'd like your advice on this
- nos 68 chevelle full quarters
- need a how to book or vid.
- primers
- Core support installation
- ??? for More amibtion then brains
- Chevelle & El Camino Brackets the same?
- Dash switches
- Elky bed cargo area/lid
- roof insulation
- Cost to hang panels
- any good classic car body men in kansas city
- 66 door repair kits?
- underside body & firewall color?
- 69 Chevelle grille brackets
- One Wierd Problem With Paint
- afraid to strip
- paint stripper from POR
- Trunk lid tension adjustment
- has anybody powder coated alternator housing
- spray bombed part of the car
- Paint booth rental in Phoenix/Mesa area?
- help with cowl and valance painting
- opinions on which color to use.
- Bought a set of used doors this weekend and.....
- How to paint flexible bumper cover
- paint matching-att mrt senior
- Weather Stripping
- Rust problems
- Blending acrylic lacquer
- Headlights wont line up with outer pieces
- 69 70 SS Dark Grey Wheel Insert Paint code?
- Could use some help with Bumper not aligning
- Martin Sr Basic needed
- info on eastwoods rust encapsulator
- paintless dent repair
- frame
- Trunk lid tension rods
- Vinyl Top Trim Help
- Sag in Paint.
- Antennae Removal on 67SS
- Frame recondition question
- Doors stuck!!!!
- Painting steps?
- Rear Patch panel installation
- Vinyl top molding clips location
- body prep question....
- Rust repair panels??
- Welding question
- How to fix a rip in convertible top?
- Phantom Blue
- Body bushings square nut access 67 malibu
- in what order should I replace this metal?
- 69 Tail-light extensions
- 69 trunk pan replace
- Whats necessary for a good paint job
- door alignment
- HOOD LETTERING 64 ELKY
- Body shops in San Francisco....
- Body parts in Canada?
- 69 SS Chevelle Grill Color?
- antenna
- fiberglass hoods
- sport mirrors
- C.I. Letters
- block sanding question
- can somebody recommend a Body Shop in Central/Western PA.
- Need door latch
- 69 Rear Bumper Quality
- ss stripe stencils
- the radiator support rale?
- Thoughts of a bored bodyman
- front clip removal?
- Monte Carlo Question
- Problems with U S Bodysource
- cowl to hood seal
- Window Felts
- Anyone heard of this welding wire??
- Suppliers of Fenders and Rear Quarters '69
- POR or Spray? Opinions?
- Two Questions...one frame, one body..
- 68 Chevelle Body Mystery
- 72 El Camino in butternut yellow
- 70 / 72 fender difference
- rare molding
- what do i need for ss hood?
- what do i need for ss hood?
- Suggestions for paint color(s) reference
- Can naptha be used to clean paint guns?
- CONV. PILLAR POST LEANING BACK
- Hood hinges: fix or replace?
- Finishing a "Enamel" paint job ??
- Tips on sanding uneven patches of primer/surfacer
- HELP!!How do Vent window assemblies come off???
- 68 Vent Window Install/Alignment AAAARRGHHH!!!
- 69 SS color of rear panel
- aerosol primers
- Primer Gone Bad?
- paint blisters!!!
- Cubic Inch / number Emblems?
- Attention 71SSBB
- Fenderwell Paint
- Resto help in N.C.
- 68 stinger hood
- Doors
- I hope I didn't bite off more than I can chew
- Homemade "Rotisserie"
- Filler primer?
- wheres MARTINSR's basic of body panel alignment?
- 69 chevelle Baldwin hoods
- trim mounting clips/studs for 66 eyebrows
- filler blues.....
- Body Sealer
- ? for MARTINSR about MartinSenour
- The Velle is finally getting painted! need help with paint code.
- powder coat or jet coat
- Question for the Bodywork Experts? DIY or Pay a Pro?
- 3M double sided body trim tape
- Lesonal base and transtar clear.....how do they rate?
- Collision Estimate Software
- LOOKIN FOR 68-69 4 door with no posts between side windows.
- This may be a really wild idea - filling frame
- Who has the oldest powder coated frame
- Body Bushings Help!!
- Help!!!!! I found some bad rust.
- Door Tag
- 03 chev electron Blue 21 and arrival blue 91....what's the diff???
- rear panel molding
- por patch
- trunk weatherstrip
- ok, so heres what im doing
- dipping quarter panel
- So my saga is not rare... I still hate it
- What should my welds look like???
- whirly jig rotisserie
- Any of you have any experiance with replacing the rear frame section on a Chevy PU?
- information on 69 chevelle quarter panel
- Proper steps for painting aluminum- Help!
- rear deck filler
- rear/quarter emblems
- 70-72 Convert. Goodmark 1/4?
- Door Skins
- buffing experts, what am I doing wrong.
- Rear Window to Trunk Panel
- First post
- general questions for guys who work in production shops
- 68/69 grill
- What to charge?
- Swap Cowl Hood For Regular Hood
- Hobby Welder
- Time estimation...
- Hybrid: 70 front 71-72 back
- heavy chevy?
- I don't know how many of you have used...
- Oxidized paint
- Sealing back side of weld?
- Eastwood's trunk paint
- Full rear quarter panels for 69
- Mirrors for 70 Chevelle
- Are '66 Converts hard to get parts for??
- body by fisher
- 66 " A " body frame specs.
- All in one Primer
- Inner Fenders...again (I know, I know)
- painting a flapper hood and grill for 70 Velle?
- Stretching/modifying front wheel opening?
- 72 Decklid Lock Cyl. Removal
- need some guide lines for primer
- need to remove the rear trunk panel ('66)
- ran out of paint, what to do before re-shoot?
- Paint Stains
- 67 Chevelle Body Work
- Clear coat on intakes
- door problem
- Red Oxide Primer?
- Bedside molding installation
- body sitting crooked.... please read
- SS Taillight extensions
- '69SS Grille moldings...any good ones out there?
- New fuel lines
- '66 Sedan frame
- do i take the car all the way down to bare metal?
- MartinSr and others - Glasurit Auto Paint?
- 65 Radiator support
- paint code 26 1971....
|
Pages :
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
[23]
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
| ||