Are the Pro-Filer heads "as cast"? I assume the AFR's are CNC'd? The RFD heads are CNC'd or hand ported?
An as cast head done by Darin ???
You are kidding right,,, can't believe you even asked that
All the heads are CNC ported with the RFD & Profiler massaged a little
To be clear the RFD head was designed by Curtis, the Profiler by Darin & the AFR by Tony
All are copied after design by the CNC
Both the RFD & Profiler had some hand massaging done after the CNC to bring them more in line with what the original design was
The Profilers are the set that pics were taken of at the Chicago show & are up on Chad's site
The AFR's are Tony's newest creations & the only one's in existance right now but should be available in the near future
I will put up some pics of the AFR's later they are still on my camera.
Curtis asked that I not post pics of his ports so I must honor that
If I had the time to play with more cams for each head I know any one of these is capable well over 1000HP in a 555 compression engine with a different intake
Tony was very "tempted to massage" his but felt most would like to see what comes out of the box as delivered to everyone so that is what was used